3D Printing Forum

Thank for the information. I do make sure the gantry is level with the top of the machine. I can't check level against bottom rails as they are not level with each other (see below) I did notice a couple of other things. 1) I was not being exactly precise where I placed the print head while making t...

I am having a hard time with the bed maintaining level. I have the Creality CR-10 S5. From what I have read, the bed should stay level for some time once set. My experience has been that the bed does not stay level very long. In fact, if I move the bed back and fourth, this can cause it to go out of...

I figured it out. Creality had swapped the tabs of the x-axis and y-axis cables. Works now. Thanks for all the replies.

Post an Image of what you are 3D Printing verses what is actually printed. If it is mirrored right to left X axis or if it is mirrored top to bottom the Y axis cabling could be incorrect. Now if both the X and Y Axis are mirrored then the X and Y cable could be reversed, this could be caused by fac...

Post an Image of what you are 3D Printing verses what is actually printed. If it is mirrored right to left X axis or if it is mirrored top to bottom the Y axis cabling could be incorrect. Now if both the X and Y Axis are mirrored then the X and Y cable could be reversed, this could be caused by fac...

LePaul wrote: ↑July 18th, 2019, 9:01 am I've heard of this happening before with Cura. A good article that might help...

https://drmrehorst.blogspot.com/2017/08 ... rigin.html

Thanks, I will read this and get back with a repost.

I am using Ultimaker Cura with a Creality CR-10 S5 3D printer. When I go to print, the x-axis appears to be going in the wrong direction. For example if I print an "L", it will be backwards. I have checked all settings and everything looks good. Motors have been verified connected correctl...