Search found 4 matches
- September 1st, 2023, 3:51 am
- Forum: Software and Firmware Discussion
- Topic: Cura Machine Settings G-Codes
- Replies: 6
- Views: 8957
Re: Cura Machine Settings G-Codes
Wow! Its been a good few years since I was last active on the forum, but I've just blown the dust off of my trusty old Hictop and fired it up. Previous to switching my machine on I had installed Cura 4.3.0. But after a hard failure a couple of years ago I lost my Cura G-code settings. So running a ...
- July 26th, 2023, 3:32 am
- Forum: Software and Firmware Discussion
- Topic: Begginer
- Replies: 6
- Views: 13246
Re: Begginer
It appears that you have a Hictop Prusa i3 3DP08 or 3DP18 acrylic. With 3D Printed Filament Spool Supports. When you select the 3DP18 Manual the 3DP08 Manual is shown. HICTOP-3DP08-Prusa-I3.jpg Firmware located Here Users Manual located here To address this discrepancy, I recommend reaching out to ...
- July 20th, 2023, 1:57 am
- Forum: Software and Firmware Discussion
- Topic: Firmware and software
- Replies: 6
- Views: 12990
Re: Firmware and software
First thing I am going to do is upgrade link to Marlin from Hictops nasty firmware that does not save settings! So you recommend 2.0 or 1.1.9bf? I found Roberts great work and posts very helpful, but I only understand enough to know I dont understand anything yet, but I want to start on the ”right”...
- October 19th, 2022, 3:41 am
- Forum: Software and Firmware Discussion
- Topic: Marlin manual Bed leveling Leveling increment tweaking
- Replies: 10
- Views: 19345
Re: Marlin manual Bed leveling Leveling increment tweaking
If its of any use I redesigned an Auto Bed Leveling Sensor Mount. Unlike the 3 part assembly thats on Thingiverse, my one is only a two part and fits the linear bearing housing perfectly. If I get the time I guess I should upload the files onto Thingiverse as its easy to fit and adjust. Can we get ...