3D Printing Forum

UPDATE: There is SO much incomplete and just plain wrong "information" out there... Turns out this machine IS updating the firmware, it's just not behaving at all as everything I've read or watched on the 'tube says it should. Yes, I was using "pre-fab" firmware. I've learned the...

Hi Forum Folke, Likely a stupid newbie question, but WHICH *.h file am I supposed to use to set up my firmware: configuration.h, configuration_adv.h, or BOTH in some manner I have yet to discover? My current understanding is use configuration.h if you're just sticking with basic settings, and use co...

Hi folks, Machine: Creality Ender 3. Alterations from original "as recieved" setup: BigTreeTech SKR Mini-E3 -ver- 2.0, with the BigTreeTech TFT35 E3 touchscreen display. Managed to update the firmware with this setup; talk about a vertical learning curve! Just installed an Antclabs BL Touc...

Hi Forum Folke, Just installed a direct-drive extruder setup on my Ender 3, and printed a 20mm XYZ cube. Initial weirdness was due to my slicer (Cura) settings, which I fixed. Now, though, even though it prints a good cube, 20mm plus or minus 0.03 on all faces, no elephant foot, no ringing or ghosti...

Hi Forum Folke, First post here. I'm still fairly new to 3D printing, and I don't deal with coding in any way, so apologies if this is an idiotic question. Creality Ender 3 printer. 4.2.2 control board. Manual bed leveling. Single Z stepper (changing to dual soon.) Is there any way to back up my exi...