3D Printing Forum

You just need to modify the steps definition. Lead screws should be ~398. #define DEFAULT_AXIS_STEPS_PER_UNIT { 80, 80, 398, 94.496214 } Would this be in the config file? If so, it would be difficult to translate that in the HEX file provided from Hic's website. I'm under the assumption that only &...

Try this link: https://www.hic3dprinter.com/pages/firmware. It shows the firmware for the 3DP08-3DP11. Not sure if it works with the Z screws your kit came with though (at one point, they switched everything to leadscrews apparently). Thank GrueMaster, that code worked, though it was just to test t...

Hello everyone, My current problem is finding the original firmware for my board after attempting a botched upgrade to my Z-axis screws and hot end upgrade (mainly the screws). Background on how I got here: for around 6-8 months in 2016 I ran my printer without any major hardware modifications; most...