Z-axix linear bearings

Talk about your experience with Ultimaker printers
rowiac
Reactions:
Posts: 3
Joined: August 14th, 2016, 11:44 pm
Location: California, USA
3D Printer(s): Ultimaker Original Plus

Re: Z-axix linear bearings

Post by rowiac » April 28th, 2017, 4:59 pm

I had the same positive result by changing to the Misumi LM12 bearings. Little did I know at the time that I could have had them replaced under warranty. My UMO+ was only a couple of months old when I replaced them and the warranty is one year.

Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 12 guests