Page 1 of 1

Polyalchemy Elixire Gold Rush

Posted: August 11th, 2018, 3:17 pm
by B_HepSpringer
Been trying to print with this stuff but having loads of problems tried different settings in S3D but still rubbish
temp 215
layer ht .20
speed 1450 mm/min
its when the layers change you can see very clearly the change over even in vase mode where the layer changes to the next will post a pic tomorrow but at moment its heading for the Bin..


or I forgot im using the matchless nozzles from 3dSolex

I turned the extrusion multiplier down to 88 from 1.0 which helped a bit, but its still terrible.....

Re: Polyalchemy Elixire Gold Rush

Posted: August 11th, 2018, 5:01 pm
by LePaul
I've printed with it extensively and did a video on it a while back