Layer splitting with ABS

Your ABS brand not mentioned in the categories? Chat about it here
Lez0
Reactions:
Posts: 156
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon

Re: Layer splitting with ABS

Post by Lez0 »

Found out why part of the print was not very good.
I used Cura with "Use adaptive layers" set with the default settings.
This was used to cut the print time down, but resulted in crappy walls.
I wouldn't be using this setting again.....

Lez0

Post Reply

Return to “ABS Filament General Discussion”