Page 1 of 1
PrusaSlicer
Posted: November 3rd, 2020, 10:26 am
by Roberts_Clif
Decided to print a
pre-sliced model G-Code from Prusa Printers.
It printed perfectly. Now I need to go through the
Modifier meshes tutorial to see how I can do this myself.
Printed On MY Hictop 3D12
Re: PrusaSlicer
Posted: January 24th, 2021, 8:54 am
by Roberts_Clif
Another reason to start using PrusaSlicer
When slicing this Tablet Holder it would require a print time of 7 hours 19minutes to print model.
Slicing with a 0.24mm the print has a stair stepped ledge in the area painted green.
Using PrusaSlicer this area is used as a modifier where I can change the layer height to .06mm in the green area.
Thereby changing the print time to 3 hours 20 minutes. With a print model that looks much smoother and quite nice.
Re: PrusaSlicer
Posted: March 4th, 2024, 9:29 pm
by Roberts_Clif
Have a question that was asked of me an have no way to answer, will post here to see if any of you have an answer
So, I just learned a thing....
I have a 3MF file that was sliced on Bambu Slicer. I went to open it on Prusa Slicer and it won't open. So I downloaded Bambu Slicer and it opens beautifully with all the colour painting done. If I then save it as "generic" 3MF, I can open it on Prusa Slicer, but it opens the same as an STL, with no colour changes.
Does anyone know a way to "convert" the 3MF between slicers and keep the colour changes intact?