Issue with printing, sliced with Cura

Discussion of Ultimaker's open-source Cura software
Post Reply
jsrfo
Reactions:
Posts: 2
Joined: April 4th, 2021, 1:04 pm
3D Printer(s): Sovol SV01

Issue with printing, sliced with Cura

Post by jsrfo »

Having issues printing this model sliced with Cura. At the level the three holes, there is thinning between the holes.

Can't figure it our after trying different retraction, combing, and Z Hop settings.
20210403_172539.jpg
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Issue with printing, sliced with Cura

Post by Roberts_Clif »

This is quite a frequent problem with Cura and happens quite often.
when any change happens on Z-Axis, could be many changes to the shape of the model, the outcome is always the same style texture surface change.


Look at this example
Right Lead-Screw comparison.jpg
jsrfo
Reactions:
Posts: 2
Joined: April 4th, 2021, 1:04 pm
3D Printer(s): Sovol SV01

Re: Issue with printing, sliced with Cura

Post by jsrfo »

So, is there a resolution for this type of issue? I've been trying for months to resolve it, and nothing seems to work.
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Issue with printing, sliced with Cura

Post by LePaul »

4.9 Beta just came out....worth a try?
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Issue with printing, sliced with Cura

Post by Roberts_Clif »

Do not know if this is a solution or not, here goes.

I have printed most recent models with PrusaSlicer 2.3.0 it is more complex to setup though the printed model show results.
I still use Cura for other models that need less perfection.
Last edited by Roberts_Clif on April 8th, 2021, 8:07 pm, edited 1 time in total.
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Issue with printing, sliced with Cura

Post by LePaul »

There's also the Cura Users group on Facebook you could ask
Post Reply

Return to “Cura”