How to define a new printer in Cura?

Discussion of Ultimaker's open-source Cura software
Post Reply
reibuehl
Reactions:
Posts: 506
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

How to define a new printer in Cura?

Post by reibuehl »

I would like to create a Cura machine setting for the Fabrikator Mini 1.5, but I am stuck with the measurements for the printhead. Is there a guideline how to measure the x-min, y-min, x-max, y-max and nozzle offset values? Maybe a little sketch that shows how they are meant?
Post Reply

Return to “Cura”