Anyone recognises this printing symptom?
Posted: August 1st, 2020, 1:55 pm
Hello
I use a Dremel 3D45 and I´m printing using their slighly altered version of Cura. Anyway, I have been printing a 3 bladed object and one of the blades always comes like the photo. Any idea what it could be? Looks like the start/end of the layer print but no idea where to look to solve it.
Any suggestions would be great.
I use a Dremel 3D45 and I´m printing using their slighly altered version of Cura. Anyway, I have been printing a 3 bladed object and one of the blades always comes like the photo. Any idea what it could be? Looks like the start/end of the layer print but no idea where to look to solve it.
Any suggestions would be great.