Page 1 of 1

Model will slice but printer don´t read the file

Posted: November 9th, 2020, 8:41 pm
by kiloparsec
I use Ultimaker CURA 4.7 to generate the file for a Anycubic Mega Pro Printer but when I put the SDcard in their slot, the printer detects de SDCard but doesn´t read the file (only demo files currently are read), I don´t have any Idea about what happens....really I need some advice.

best regards

Re: Model will slice but printer don´t read the file

Posted: November 10th, 2020, 1:39 am
by Lez0
Have you tried a different SD card. The one you are using may be faulty.

Re: Model will slice but printer don´t read the file

Posted: November 15th, 2020, 11:10 am
by GrueMaster
Also, I don't think the firmware will work with subdirectories or files longer than the dos 8.3 naming convention. Check those as well.

Re: Model will slice but printer don´t read the file

Posted: November 15th, 2020, 10:54 pm
by LePaul
Make sure the file name is short, the anycubic printers (i have a Chiron) can be fussy like that