Print Multiple of same part in one set up One at a time?
Posted: December 18th, 2020, 5:26 pm
Hello Forum,
Is it possible to build a Cura Project were you would have multiple examples of the same part to be printed, but your printer finishes each part before going to the next one? I want to eliminate the wasted time, wisps of filament, room for error, of moving from one part to another when the printer is at the same layer/Z height. I also do not want to waste the time of the printer running through the bed level check for a part that takes less than 10 minutes to print.
Print three of the same part but finish each one top to bottom before moving on to the next example...
Thanks,
CismontGuy
Is it possible to build a Cura Project were you would have multiple examples of the same part to be printed, but your printer finishes each part before going to the next one? I want to eliminate the wasted time, wisps of filament, room for error, of moving from one part to another when the printer is at the same layer/Z height. I also do not want to waste the time of the printer running through the bed level check for a part that takes less than 10 minutes to print.
Print three of the same part but finish each one top to bottom before moving on to the next example...
Thanks,
CismontGuy