Cura rumbling sound on prints

Discussion of Ultimaker's open-source Cura software
Post Reply
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Cura rumbling sound on prints

Post by LePaul »

I have been printing some parts that take 4.5 hours and thought I would try doing so without Zhop....leaving Combing (All) and Avoid Printed Parts When Traveling. While the print comes out OK, that rumbling sound is quite annoying!

Then again... turning Combing Off and turning Z Hop on gives a pretty noisy experience too

Tips on a less noisy approach? :)
Post Reply

Return to “Cura”