Impressive list of mentions...
https://ultimaker.com/en/blog/38784-wha ... in-cura-24
Cura 2.4 is out!
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura 2.4 is out!
p.s. Where do I find if I am running the latest firmware for my Ultimaker 2+ ? And what's available on the UM site?
- Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: Cura 2.4 is out!
I highly doubt they will ever update a um2/um2+ firmware.
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Cura 2.4 is out!
And even if they did...I would use TinkerGnome's FW...just as I use Amedee's FW for my UMO+
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura 2.4 is out!
I do for my UMO (Amedee)
- Titus
- Reactions:
- Posts: 252
- Joined: February 9th, 2016, 10:20 pm
- 3D Printer(s): Ultimaker Original+HBK
Re: Cura 2.4 is out!
I still run stock(upgraded ofcourse) firmware for my UMO+HBK Isn't there an update from time to time?
Perhaps I should look into Amadee-ware? Any main benefits? I'll look for the topic some day.
Perhaps I should look into Amadee-ware? Any main benefits? I'll look for the topic some day.