print only shell, not walls
print only shell, not walls
Hello, it's first time I post in this forum. I use 3d printer since three years, just for hobbies. I have a M3D and then I got a Mooz2. M3D has its own slicing software integrated. I have a simple model (attached) which I successfully printed with M3D. Now I try using Cura (3.2.1). Here attached settings. For same model printed I get only outer shell, no walls, no base thickess. May I get a help? thanks.
- Attachments
-
- piede lampada rev2.1 fixed.stl
- (149.3 KiB) Downloaded 554 times
- GrueMaster
- Reactions:
- Posts: 522
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
Re: print only shell, not walls
I checked your model on my system (same Cura), and the only way to get it to do what you are saying is if I have Spiralize Outer Contour enabled under Special Modes. Check that setting.
Re: print only shell, not walls
Yes, the option 'Spiralize Outer Contour' is enabled. So, I should disable it and re-try, correct? thanks
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: print only shell, not walls
Yes shut that off
Re: print only shell, not walls
It works, thanks!
I do not know Cura in details. One question: in my model posted there is a small hole in vertical, at the mid of a simple cylinder, a sort of glass. The layers printed at the same height of hole are not very good, those printed inside the part. I wonder if I could test some alternative settings which could get rid of such 'faulty' layers.
I do not know Cura in details. One question: in my model posted there is a small hole in vertical, at the mid of a simple cylinder, a sort of glass. The layers printed at the same height of hole are not very good, those printed inside the part. I wonder if I could test some alternative settings which could get rid of such 'faulty' layers.
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: print only shell, not walls
Here are my Cura settings for 2.6.2 they are importable to 3.2.1
Re: print only shell, not walls
Thanks. I am going to try the version 0.2 mm. Thanks