Page 1 of 1

3.3.1 Cura takes an hour longer!

Posted: April 30th, 2018, 5:53 am
by Lez0
I have just upgraded Cura to 3.3.1
I have a bezel 283x184x18.5 in PLA.
I have some custom setting, but nothing too strange.
In Cura 3.2.1 it takes 8 hours 4 minutes.
I Cura 3.3.1 with the same settings it takes 9 hours 10 mins, according to Cura, which is usually pretty close to guessing the time.
Why an hour longer to print?
Has anybody else noticed this.

Lez0

Re: 3.3.1 Cura takes an hour longer!

Posted: April 30th, 2018, 8:04 am
by nallath
Because certain settings might have changed. We constantly tweak settings, but it's impossible to have settings that improve things for everyone.

Re: 3.3.1 Cura takes an hour longer!

Posted: May 2nd, 2018, 11:53 am
by LePaul
Count yourself lucky !

Do a print with S3D...the print time is about 20% off...it takes a lot longer!

Re: 3.3.1 Cura takes an hour longer!

Posted: May 7th, 2018, 10:09 am
by Lez0
I reported the issue and it seems to have been resolved, it didn't take long.
It's just as well I left version 3.2.1 on the PC when I upgraded to 3.3.1,
I can use the older version to get quicker prints.

ps I wasn't complaining I was just letting everyone know