i wanted to try to figure out Simplify 3D (again)
Downloaded the latest installer (3.1.0)
Going through the settings for the Ultimaker 1
Still not a default profile for the Ultimaker with heated bed....annoying...
So in the temp settings I set the PLA temp to 216 I see it uses T0
Now not sure what to set for heated bed?
Simplify Ultimaker Original with Heated bed question
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Simplify Ultimaker Original with Heated bed question
Or you could have just said T2.....nevermind. I'll stick to Cura. Not worth the attitude replies
- Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: Simplify Ultimaker Original with Heated bed question
Sorry lepaul, I love to help but rewriting all its time. Also, on that post there are some very interesting points that could help you start a umo&bed profile.