Re: Simplify3d basic guide
Posted: August 2nd, 2017, 3:04 pm
In S3D, On the machine control panel there are 3 macro buttons you can program, I did set them for atomic clean temperatures so Macro 1was heat nozzle to 210, macro 2 was heat nozzle to 96.
Was ideal for atomic cleaning when having to do a lot of cleans with a messy filament.
But because i didn't know how to correctly save them I had to type them each time I opened the control panel.
I can control the part cooling fans no problem it was the rear fan I wanted to be able to switch off once the nozzle block had cooled to room temperature or about 30'C
Was ideal for atomic cleaning when having to do a lot of cleans with a messy filament.
But because i didn't know how to correctly save them I had to type them each time I opened the control panel.
I can control the part cooling fans no problem it was the rear fan I wanted to be able to switch off once the nozzle block had cooled to room temperature or about 30'C