Have a print that has problems? Need some feedback? Post it here.
5 posts • Page 1 of 1
so i bought a new heat sink but i don't know how it has a gap and the filament just get jam, did i bought the wrong tipe or am I making something wrong? you can see the heatsink and the clogged.
- Posts: 3329
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
What hot end/heat sink package is that....or is this stock with your printer (which is?)
i'm not really sure what you mean, but i bought the printer and it have a heat sink like that so i bought exactly the sameone but it has that wierd gap tbh i don't know what is going on haha, i put a photo of the default extruder and heatsink