Hello,
When I added my STL file to Cura I got this error message:
And here’s how my modal looks like:
Attached my STL file
Is there a way to fix it?
Thanks!
Your modal is not manifold - error message
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Your modal is not manifold - error message
I tried to open this on my Cura and it was gigantic. I used my Anycubic Chiron profile which is a 450 x 450 x 500 bed volume
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Your modal is not manifold - error message
I opened and in the same happened had to scale down from 100 % to 25.4% still was over my bed size so scaled the Z- to my max height 190mm.
I sliced the model while it was laying on its side at 25.4% two oval shaped orbs showed the lower third of the model and the top third.
For some reason the middle section was not there.\
I sliced the model while it was laying on its side at 25.4% two oval shaped orbs showed the lower third of the model and the top third.
For some reason the middle section was not there.\
Re: Your modal is not manifold - error message
Thanks!
I’ll fix the file size.
When I resized and sliced it, it looks like this:
Regarding the error message is it related to the top section? Where my Vase is open?
I’ll fix the file size.
When I resized and sliced it, it looks like this:
Regarding the error message is it related to the top section? Where my Vase is open?
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Your modal is not manifold - error message
Do not have an answer your last question.