Why is this happening?
-
- Reactions:
- Posts: 1
- Joined: April 12th, 2020, 4:36 pm
- 3D Printer(s): Monoproce mini select v2
Why is this happening?
I have a monoprice mini select v2 and it was working fine for a few prints but then this started happening and I don't even know how to describe it to sind a solution. It always happens on that side of the bed. Any help will be appreciated
- Roberts_Clif
- Reactions:
- Posts: 1372
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Why is this happening?
This is a bed leveling issue.
On one side it prints correctly, the other side is squished until the filament can no longer be extruded.
However I do not know how to correct at this time, Will search the web to see what can be found.
Watch the Bed Leveling video in this Web Link.
https://www.mpselectmini.com/bed_leveling
On one side it prints correctly, the other side is squished until the filament can no longer be extruded.
However I do not know how to correct at this time, Will search the web to see what can be found.
Watch the Bed Leveling video in this Web Link.
https://www.mpselectmini.com/bed_leveling