Ripples in the surface layer of my prints, Help!
Posted: July 20th, 2020, 10:00 am
Hia!
I'm pretty new to 3D Printing, and I've recently been having a problem with getting raised ripples on the surface layers, (the first layers come out fine, its just the finishing ones). The sides and bottom layers all come out fine, it just seems to be having problems putting the final layer over the infill.
I have a CR - 10 and I'm using standard PLA.
I'm not sure whether i need to up the infill density because its such a large flat face? Or if it's something to do with the extrusion or something else entirely!
Any advice much appreciated, thanks!
(sorry the pictures aren't great, its hard to see on the white filament!)
I'm pretty new to 3D Printing, and I've recently been having a problem with getting raised ripples on the surface layers, (the first layers come out fine, its just the finishing ones). The sides and bottom layers all come out fine, it just seems to be having problems putting the final layer over the infill.
I have a CR - 10 and I'm using standard PLA.
I'm not sure whether i need to up the infill density because its such a large flat face? Or if it's something to do with the extrusion or something else entirely!
Any advice much appreciated, thanks!
(sorry the pictures aren't great, its hard to see on the white filament!)