Strange "spiders web"

Have a print that has problems? Need some feedback? Post it here.
Post Reply
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Strange "spiders web"

Post by Lez0 »

Hi all
Here is a strange thing with my prints. I need to print a few copies of a part. They print OK except for what I can only describe as a spiders web, see photos. It's not a problem to cut them off, I just wondered why they are there, everything else is OK.
Very weird.
Anybody else had this?

Lez
Attachments
2020-07-28 10.47.22.jpg
2020-07-28 10.46.58.jpg
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Strange "spiders web"

Post by Roberts_Clif »

Retraction can cause the stringing, though stringing can be caused by filament that has absorbed moisture.

Even it you set your retraction correctly a pressure caused by moisture boiling can cause a fine stringing effect.

I purchase the below moisture eliminator from the Dollar Store and store my filament in a water proof storage container below
Moisture Eliminator.jpg
Post Reply

Return to “Help me fix this print!”