Hello
I am new to the forum and would need help with the 3dBenchy print. As you can see from the attached photos, I get blobs in the bow onthe boat while the side looks good. Have tried 2 PLA rolls and the result is the same. I use Cura 4.8 as slicer. I have done the esteps calibration for the extruder.
/ Togge
Blobs in the walls
- Roberts_Clif
- Reactions:
- Posts: 1372
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Blobs in the walls
As you might have noted the bumps are on the Bow of the boat.
This could be that you are trying to print a little too fast on the 3dBenchy.
What settings are you using to slice the 3dBenchy
This could be that you are trying to print a little too fast on the 3dBenchy.
What settings are you using to slice the 3dBenchy
Re: Blobs in the walls
I print the walls 40mm/s
- Roberts_Clif
- Reactions:
- Posts: 1372
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Blobs in the walls
Save your slicer profile and post.
Settings > Profile > Manage Profile > Click
Select the profile you are using Export an attach to next post.
I would think filament moisture only the blobs only occur on beveled edge..
Settings > Profile > Manage Profile > Click
Select the profile you are using Export an attach to next post.
I would think filament moisture only the blobs only occur on beveled edge..
Last edited by Roberts_Clif on November 29th, 2020, 7:08 am, edited 1 time in total.
- LePaul
- Reactions:
- Posts: 3966
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Blobs in the walls
I'm willing to bet that's the randomized z seam
Re: Blobs in the walls
Thank you for helping me. I tried to lower the printspeed to 30mm / s. But there are still blobs in the print. Attach photo and Cura setttings.
- Attachments
-
- Standard Quality 0.2mm low wall speed.zip
- (558 Bytes) Downloaded 234 times