Vexing Problem: Warped Print

Have a print that has problems? Need some feedback? Post it here.
Post Reply
lothian
Reactions:
Posts: 4
Joined: October 17th, 2021, 1:31 pm
3D Printer(s): LONGER3D LK4 Pro

Vexing Problem: Warped Print

Post by lothian »

Longer LK4 Pro (amzn.com/B08JPRL5BJ)
HATCHBOX PLA (amzn.com/B00J0ECR5I)
Fusion360 and Cura v4.11


Each time I print the object below--70 x 32 x 8mm block with a few channels--the thing comes out warped as shown in the images. I've generated plenty of objects with this printer, and I've never experienced this problem before.
IMG_2270.JPG
IMG_2269.JPG
IMG_2268.JPG
IMG_2267.JPG
IMG_2266.JPG
I lowered/raised printer's plate temp; I increased/decreased Quality/Infill settings in Cura; I moved the print location on the plate--same result every time. I'm stumped.

This is the extent of my troubleshooting knowledge, and now I reach out out for suggestions leading to a solution.
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Vexing Problem: Warped Print

Post by Lez0 »

It looks like it's lifting off the build plate, try putting a skirt around the part to hold it to the build plate better.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Vexing Problem: Warped Print

Post by Roberts_Clif »

Have never seen PLA warp like this before.
Could you post your basic Cura settings. Temp, Print Speed, Layer Height, infill percentage ect.
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Vexing Problem: Warped Print

Post by Lez0 »

I've had this happen, mind you it could have been due to a slightly blocked nozzle.
Post Reply

Return to “Help me fix this print!”