Paul,
Cannot seem to get pictures to post. Any suggestions?
Chip
---
Pictures/Attatchment issue
- Titus
- Reactions:
- Posts: 252
- Joined: February 9th, 2016, 10:20 pm
- 3D Printer(s): Ultimaker Original+HBK
Re: Pictures/Attatchment issue
I uploaded them to imgur and linked them here. Couldnt find an upload button
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Pictures/Attatchment issue
Are you using Attachments (use full editor)...there's an option to click Inline so it shows in the post too
- Chip Luck
- Reactions:
- Posts: 191
- Joined: February 11th, 2016, 9:12 am
- Location: Central Florida
- 3D Printer(s): HICTOP Reprap Prusa I3
- Contact:
Re: Pictures/Attatchment issue
OK Paul, will give that a try. Thanks aging for setting up the board, hope I can migrate some more members here!
Cheers,
Chip
---
Cheers,
Chip
---
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Pictures/Attatchment issue
It's a different way to affix pictures, i agree....but it works really well. It will display a thumbnail and if clicked, go full size
- Chip Luck
- Reactions:
- Posts: 191
- Joined: February 11th, 2016, 9:12 am
- Location: Central Florida
- 3D Printer(s): HICTOP Reprap Prusa I3
- Contact:
Re: Pictures/Attatchment issue
Thanks Paul. BTW: TRYING to get the fellow HICTOP's users over here. I'll talk to Tood B. about it some more. Thanks again.
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Pictures/Attatchment issue
We're here for you!