video tutorial here to learn more https://www.youtube.com/watch?v=48Inse5kwdE
COVID...stay healthy
Re: COVID...stay healthy
With everyone so focused on printing masks, SelfCAD decided to design something that will help people outside of the quarantine. Take a look at the
video tutorial here to learn more https://www.youtube.com/watch?v=48Inse5kwdE
video tutorial here to learn more https://www.youtube.com/watch?v=48Inse5kwdE
-
markophillips
- Reactions:
- Posts: 1
- Joined: September 17th, 2020, 3:42 pm
- 3D Printer(s): Stereolithography
Re: COVID...stay healthy
Good to hear that you are doing 3D printing even in this hard time of covid.LePaul wrote: ↑March 19th, 2020, 12:42 pmI've been working from home for a week, since I traveled West where there were infections.
But so far, I am fine
And getting a lot of 3D printing done
-
KaithlynMoore
- Reactions:
- Posts: 1
- Joined: December 10th, 2020, 2:38 am
- 3D Printer(s): Snap Maker
Re: COVID...stay healthy
Looks like you people know much about 3D printers. I need advice in selecting some high performing 3D printer currently I'm using snapmaker 2.0 and I'm not satisfied with it. It would be great if you would suggest me some good 3D printers based on your experience.
-
LePaul
- Reactions:
- Posts: 3588
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): I can't name all 14
Re: COVID...stay healthy
What sort of print volume?KaithlynMoore wrote: ↑December 10th, 2020, 2:52 amLooks like you people know much about 3D printers. I need advice in selecting some high performing 3D printer currently I'm using snapmaker 2.0 and I'm not satisfied with it. It would be great if you would suggest me some good 3D printers based on your experience.