Page 2 of 2
Re: COVID...stay healthy
Posted: April 28th, 2020, 9:52 pm
by Sammy50
With everyone so focused on printing masks, SelfCAD decided to design something that will help people outside of the quarantine. Take a look at the
video tutorial here to learn more
https://www.youtube.com/watch?v=48Inse5kwdE
Re: COVID...stay healthy
Posted: September 17th, 2020, 4:06 pm
by markophillips
LePaul wrote: ↑March 19th, 2020, 12:42 pm
I've been working from home for a week, since I traveled West where there were infections.
But so far, I am fine
And getting a lot of
3D printing done
Good to hear that you are doing 3D printing even in this hard time of covid.
Re: COVID...stay healthy
Posted: December 10th, 2020, 2:52 am
by KaithlynMoore
Looks like you people know much about 3D printers. I need advice in selecting some high performing 3D printer currently I'm using
snapmaker 2.0 and I'm not satisfied with it. It would be great if you would suggest me some good 3D printers based on your experience.
Re: COVID...stay healthy
Posted: December 11th, 2020, 7:43 pm
by LePaul
KaithlynMoore wrote: ↑December 10th, 2020, 2:52 am
Looks like you people know much about 3D printers. I need advice in selecting some high performing 3D printer currently I'm using
snapmaker 2.0 and I'm not satisfied with it. It would be great if you would suggest me some good 3D printers based on your experience.
What sort of print volume?