So I ordered a replacement from Creality and finally got around to installing it. Very easy process, nothing difficult until..... the MINTEMP error. So here I am looking for help, here's what I've done after MUCH research and tearing the whole thing down.
- I rechecked my wire connections a million times, all is simple and as it should be.
I pulled out the thermistor from the brand new hotend and confirmed it's fine.
I checked the soldering on the backside of the board for the thermistor connection, all looks good, it's not loose.
The pins to the connector are fine.
The board looks fine.
So that's it? Suggestions??? I'm nearly ready to buy a new board at this point after having tried everything.
Thanks in advance!
Louie