Longer LK4 pro... 3d print stuck
-
- Reactions:
- Posts: 2
- Joined: January 2nd, 2022, 10:26 am
- 3D Printer(s): LONGER
Longer LK4 pro... 3d print stuck
Whenever I make a large part with a flat bottom, I nearly have to chisel the part off. I feel I am going to ruin the part or the machine. Any suggestions?
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Longer LK4 pro... 3d print stuck
Two
Start with the hot-end a fraction higher above build plate.
I use a Vinyl transfer paper tape on the build plate, Sure it sticks but with a little water the paper tape washes off quickly.
Sample image on black Chinese build surface
Start with the hot-end a fraction higher above build plate.
I use a Vinyl transfer paper tape on the build plate, Sure it sticks but with a little water the paper tape washes off quickly.
Sample image on black Chinese build surface
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Longer LK4 pro... 3d print stuck
Does the first layer have elephant's foot (first layer too squished)?
I use a PEI surface (WhamBam Bed Systems)...after the print cools, I just flex the spring steel surface and it pops off. A worthwhile upgrade in my opinion
I use a PEI surface (WhamBam Bed Systems)...after the print cools, I just flex the spring steel surface and it pops off. A worthwhile upgrade in my opinion
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Longer LK4 pro... 3d print stuck
I may want to try one LePaul it has to be 270mm x220mm
-
- Reactions:
- Posts: 2
- Joined: January 2nd, 2022, 10:26 am
- 3D Printer(s): LONGER
Re: Longer LK4 pro... 3d print stuck
Thanks, just ordered a PEI surface