Hi Guys,
I’m having an issue and on 3 of my cr10 printers On the Sam power circuit. Today 3 out of 5 are heating up the nozzle to the pre determined pre heating or print heat then immediately turning to 0 before the print can initiate. Anyone come across this?
Cr10 nozzle heating to set point then reverting to
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cr10 nozzle heating to set point then reverting to
I've never seen that
What happens if you try one printer at a time?
What happens if you try one printer at a time?
Re: Cr10 nozzle heating to set point then reverting to
I have only one printer and mine does a similar thing. It heats up and as soon as I start printing it starts cooling down. I have changed the system board to the one that the Capacitor is the new one and also replaced the Thermistor and heater element. I don't understand what the issue is any help would be appreciated.