Hi all,
I have applied a new BuildTek surface on my Fabrikator Mini and now have the unusual problem that my PLA prints stick way to good to it. Is there a way to make PLA stick less strong to it?
Best regards,
Reiner
PLA prints stick to BuildTek too much - What to do?
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: PLA prints stick to BuildTek too much - What to do?
I had a BuildTak surface and all that was required was to raise the nozzle just a tiny bit.
If it was too close it was difficult to remove the models extending the clearance allowed models removal easier.
If it was too close it was difficult to remove the models extending the clearance allowed models removal easier.
-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Re: PLA prints stick to BuildTek too much - What to do?
Good idea, I will give that a try.
-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Re: PLA prints stick to BuildTek too much - What to do?
I adjusted the Z zero hight a tiny bit and now it is working fine! Many thanks for this great hind @Roberts_Clif