Feasibility of printing this part
-
- Reactions:
- Posts: 1
- Joined: April 15th, 2020, 12:23 pm
- 3D Printer(s): none
Feasibility of printing this part
Is it possible to replicate the nose of this train (do not have an example) with a 3d printer and autocad??
- GrueMaster
- Reactions:
- Posts: 522
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
Re: Feasibility of printing this part
Yes, if you have the skill to model it. Printing is the easy part. For the best detail, use the finest setting. It will print a lot slower, but it will come out very nice. I'd print it upright with supports on the inside (if needed).
There are plenty of examples (like this) on thingiverse.
There are plenty of examples (like this) on thingiverse.