Page 1 of 1

Check out this SLA printer that uses Cura!

Posted: April 12th, 2017, 1:07 pm
by LePaul

Re: Check out this SLA printer that uses Cura!

Posted: April 13th, 2017, 5:46 am
by nallath
Suffice to say that we were quite surprised to find out that it uses Cura.

Re: Check out this SLA printer that uses Cura!

Posted: April 13th, 2017, 8:52 am
by LePaul
That's the big surprise!

I knew the Form2 knock-offs would appear within a year. And in a way, for my friends that have a Form2, that might help get the resin prices lower

Re: Check out this SLA printer that uses Cura!

Posted: February 4th, 2018, 11:00 am
by GrueMaster
I'm debating getting an SLA to muck with (yea, it's bonus time again). My 3DP-17 is good for miniatures, but not larger prints due to bed level/adhesion issues (even with a new bed, autolevel, and very fine tuning). THe CR-10S is great for larger prints, but I am having issues with detail, especially prints that have detailed undersides that require support.

Plus I am just curious.