Material for a peg

Doesn't fit a specific category here? Place it here!
Post Reply
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Material for a peg

Post by Lez0 »

Hi all
I need to 3D print a peg, it will act like pliers, see image. It needs to flex so the tips can close.
What material that is easily obtainable should I use, I don't think PLA will be good enough as it needs to flex without cracking.
With an opening of 5mm.
With an opening of 5mm.
Thanks all
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Material for a peg

Post by LePaul »

Well it's not as rigid but have you checked out Cheetah?

https://ninjatek.com/cheetah/
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Material for a peg

Post by Lez0 »

Thanks Paul.
I think this may be a bit soft for my requirements at 95A but I'll investigate it a bit more.
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Material for a peg

Post by Lez0 »

I decided to print the part in PLA just to get a feel for the size etc.
I found it flexed a lot better than I thought it would. In fact it's perfect for the job I have in mind for it.
It can flex quite a bit without a problem.
Thanks for the advice on the filament. I'll keep it mind for the future.
Lez
Attachments
2020-01-31 13.41.26.jpg
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Material for a peg

Post by LePaul »

Sounds like success!
I know there are some PLA's of varying strength. The ColorFabb I use is a PLA/PHA combination, which might make it a bit stronger.
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Material for a peg

Post by Lez0 »

I use Sunlu PLA +. I don't know what the + means. I did up the temp of the hot end 10°C just to be sure.
Post Reply

Return to “General Filament & Nozzle chat”