Marlin 1.1.7
Posted: November 6th, 2018, 8:42 pm
Was looking at the changes in Marlin 1.1.7 and found that I can Print a G26 Mesh Validation with Bi-Linear bed leveling enabled.
Marlin 1.1.7 - G26_MESH_VALIDATION and HAS_MESH (AUTO_BED_LEVELING_UBL, MESH_BED_LEVELING, or AUTO_BED_LEVELING_BILINEAR).
Too print a G26 mesh validation pattern and see how well the mesh represents the topography of the bed.
Now I am thinking that this should be a really easy upgrade from marlin 1.1.5. no side effects from a simple flash.
Other than normal confusion over the locations data is saved to the EEPROM requiring reloading Firmware defaults and Saving to EEPROM.
M502: Factory Reset - Marlin Firmware
M500: Save Settings - Marlin Firmware
While I am updating Firmware is there other features that may come in handy,
Any Suggestions.
Marlin 1.1.7 - G26_MESH_VALIDATION and HAS_MESH (AUTO_BED_LEVELING_UBL, MESH_BED_LEVELING, or AUTO_BED_LEVELING_BILINEAR).
Too print a G26 mesh validation pattern and see how well the mesh represents the topography of the bed.
Now I am thinking that this should be a really easy upgrade from marlin 1.1.5. no side effects from a simple flash.
Other than normal confusion over the locations data is saved to the EEPROM requiring reloading Firmware defaults and Saving to EEPROM.
M502: Factory Reset - Marlin Firmware
M500: Save Settings - Marlin Firmware
While I am updating Firmware is there other features that may come in handy,
Any Suggestions.