HICTOP BED TRAMMING MOD HELP

Share your hardware improvements for your HIC i3, the good and the bad!
Post Reply
wess.vic
Reactions:
Posts: 1
Joined: July 16th, 2016, 11:01 am
3D Printer(s): HICTOP PRUSA I3

HICTOP BED TRAMMING MOD HELP

Post by wess.vic »

I have been using my printer for a while now and finally decided to add the sensor. I wired it correctly and it works fine. I followed Tom's Guide on youtube to make the settings in the firmware. But everytime I send a G29 to the printer in will either home the x and y and then the z with the sensor off the bed which will then cause a crash. It will also just move the z axis intill it homes on the bed and it will stop. Then I will get a message saying home x/y before z and it wont do anything. I enabled the auto bed grid and leveling and set the grid points I have no clue what to do as of now. Please Help Thanks Vic
Post Reply

Return to “Hardware Modifications”