Well here we are again the in the Repair cycle of our 3D Printer.
Filament enters at 1.77mm expands inside throat to 2.21mm and gets stuck.
The PTFE Throat has been enlarged to 2.21mm inside the bottom of the throat and pushed into the Nozzle narrowing the channel in the nozzle.
Throat on the left, nozzle on the right. both sitting in T8-8 lead screw nuts. (Stupid Digital camera can't correctly focus this auto focus camera.)
This happens about 3 times a year. And in the process messes up about 3 or 4 printer or until if discover the throat PTFE tubing is bad again.
Throat replacement again
Share your hardware improvements for your HIC i3, the good and the bad!
- Roberts_Clif
- Reactions:
- Posts: 1372
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Return to “Hardware Modifications”
Jump to
- Announcements
- ↳ News and Announcements
- ↳ Feedback, suggestions and more
- 3D Printers
- ↳ General / RepRap Printers
- ↳ HICTOP RepRap Prusa I3
- ↳ Software and Firmware Discussion
- ↳ Hardware Modifications
- ↳ General Questions
- ↳ Original Prusa i3 MK Series printer
- ↳ Wanhao Desktop 3D Printers
- ↳ Other make/model 3D Printers!
- ↳ Large Scale 3D Printers
- ↳ Creality Large Scale 3D Printers
- ↳ Folger Tech Large Scale 3D Printers
- ↳ Tevo brand 3D Printers
- ↳ General Large Scale Printer Area
- ↳ Resin 3D Printers
- ↳ Micro 3D Printers
- Ultimaker Printers
- ↳ Ultimaker Printers Discussion
- ↳ Ultimaker S5
- ↳ Ultimaker 3 / Ultimaker 3 Extended
- ↳ Ultimaker 2 / Ultimaker 2+ / Extended & Go
- ↳ Ultimaker Original & Ultimaker Original +
- ↳ General Discussion
- Filaments, nozzles and support material
- ↳ Filament and printing material
- ↳ Special brand filaments
- ↳ PLA Filament General Discussion
- ↳ ABS Filament General Discussion
- ↳ Speciality and Experimental Filaments
- ↳ Using different nozzle sizes
- ↳ General Filament & Nozzle chat
- Getting better prints!
- ↳ Help me fix this print!
- ↳ Show off your latest print
- Software & Electronics
- ↳ Slicers and CAD Software
- ↳ Cura
- ↳ Simplify 3D
- ↳ Other Slicing programs
- ↳ CAD and 3D Modeling Software
- ↳ Slic3r
- ↳ Electronics
- ↳ General Electronics Discussion
- ↳ Firmware
- ↳ Firmware
- ↳ Wireless Printing and Controllers
- General
- ↳ General 3D Printing Conversation
- ↳ Off Topics!
- ↳ The MarketPlace
- Modders Kiosk
- ↳ General Discussion