Anyone experiment with Klipper?
Posted: January 11th, 2018, 12:16 am
I found a link to this firmware/software combination on the CR-10 discussions on Thingiverse. Looks interesting.
https://github.com/KevinOConnor/klipper
I may try it out on my little-hicci later (copious spare time and all), since I have the Marlin firmware and a complete replacement board if things go south. The software side sits below Octoprint (hence why I posted in this section).
https://github.com/KevinOConnor/klipper
I may try it out on my little-hicci later (copious spare time and all), since I have the Marlin firmware and a complete replacement board if things go south. The software side sits below Octoprint (hence why I posted in this section).