Page 1 of 1

Raise 3D

Posted: June 27th, 2016, 3:51 pm
by LePaul
I see a lot of these Raise 3D Printers are out now...I am really hoping someone posts a review soon

Re: Raise 3D

Posted: June 27th, 2016, 4:15 pm
by Izzy
I'm watching the OIO

Re: Raise 3D

Posted: June 28th, 2016, 10:42 am
by LePaul
I've been reading their support forums...I figure if there are troubles, you can spot them there!

But from what I have seen of my friend's prints...wow. Just wow.

Re: Raise 3D

Posted: June 28th, 2016, 1:53 pm
by Izzy
I take it that's wow for the Raise 3D

Re: Raise 3D

Posted: August 5th, 2016, 3:19 pm
by LePaul
Poor guy is having troubles straight out of the box


Re: Raise 3D

Posted: August 7th, 2016, 8:00 am
by ivan.akapulko
LePaul wrote:Poor guy is having troubles straight out of the box

Its looks like a epic f*ckup. No proper sd/usb reading, strange filament guide system (i really like, how its maded by BQ Witbox, for example). And this strange noise, when buildplate rises up to the nozzle....

Re: Raise 3D

Posted: August 8th, 2016, 12:13 pm
by LePaul
He posted an update, still lot's of problems


Re: Raise 3D

Posted: September 26th, 2016, 10:13 am
by joncollins
I received my n2 last Tuesday and so far so good . I'm not very good with computers or software and it took me about 1 hour to go from out the box and printing my 1st model.
The quality of prints are really good
Theres next to no noise.
The control panel is great very easy to use.
Wifi was fast and easy to set up.
Using there own software to slice and that works very well had no issues .

Will post photos later

Re: Raise 3D

Posted: November 21st, 2016, 10:45 am
by LePaul
Finally his review


Re: Raise 3D

Posted: June 15th, 2017, 11:05 am
by LePaul
Came across this today