Page 3 of 3

Re: Ultimaker Original+ -- Green Edition

Posted: March 19th, 2017, 2:36 pm
by LePaul
I agree. Glue thick can give various thickness even if you try to smudge it around

Diluted wood glue, brushing on and drying has worked great for me. I got about two months of heavy printing out of my first coating. Cleaned and re-applied...works great

Re: Ultimaker Original+ -- Green Edition

Posted: May 15th, 2017, 2:25 am
by nilrog
This weekend I assembled the last parts of the #gudoZGE and threw out the stock UMO+ feeder :)

This version is an all-PLA version as I didn't want to try printing the flexible parts with the stock feeder. So next up I will order some flexible filament and print those parts with this feeder. So by time I will slowly upgrade this feeder to become better and better. But already in this state I like it a lot better than the stock one...even if it is still not as good as it could be.

I didn't have much time to play with it yet...but I did some small test prints and they look ok with the same profile that I used before in S3D.

https://twitter.com/nilrog/status/863451095535898624