Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
- Posts: 1
- Joined: September 5th, 2017, 10:13 pm
- 3D Printer(s): Anet A8 & custom CoreXY
I had a heat creep issue also on my Anet A8. I built a custom water cooled cold end and it fixed the problem 100%. I am printing in my garage and the temps are between 80-100f. I live in houston tx, it gets HOT here. I have a vid on youtube. HEre is the link
I am 100% happy with it so far. I have not had a failed print since I have installed the new water cooled head. I am also thinking about a new design that will be smaller and more compact. It will still work with the E3D V6 hot end. I noticed that the E3D hot end has a larger thread than the chiniese hot ends I bought. I am assuming they are clones of the older E3D hot ends.
Who is online
Users browsing this forum: No registered users and 5 guests