Removing the rear bed clamps

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
Post Reply
reibuehl
Reactions:
Posts: 506
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

Removing the rear bed clamps

Post by reibuehl »

Hi all,

Is there a clever way to remove the rear bed clamps on the UM2 without taking apart half the printer?
I have a problem getting to the nuts the hold it to the heated bed.

Best regards,
Reiner
Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”