Cleaning up a PLA BLOB !

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
Post Reply
User avatar
LePaul
Reactions:
Posts: 3591
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): I can't name all 14

Cleaning up a PLA BLOB !

Post by LePaul »

I had a print fail very early into a print...but long enough for the hot end to push, shove and melt a lot of filament inside the fan should and heater block. Ahhhhh! But...I got it cleaned up!


reibuehl
Reactions:
Posts: 497
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

Re: Cleaning up a PLA BLOB !

Post by reibuehl »

I got a bit scared when seeing you with the big wire brush inside of the printer :-)

I had similar accidents before and the wiping off of the hot filament worked surprisingly good for me too. After removing what I could in cold state and then wiping off more with a heated up hotend, I always took apart the hotend afterwards and used a Dremel with a brass wire brush to cleanup the block and the screw that keeps heater and temp sensor in place.

Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”