Page 1 of 1

Prints don't start after Tinkergnome Firmware Update

Posted: March 26th, 2018, 12:12 pm
by reibuehl
I upgraded my UM2 with Dual Extruders today from Tinkergnome firmware version 16.09 to 17.10.1 using the Tinker-MarlinUltimaker2-dual-17.10.1.hex file. Now I have the strange behavior that when I start a print, the printer heats up the buildplate and nozzle and then just sits there at "Heating up... 100%" and doesn't start the print:
2018-03-25 20.28.12.jpg
Did I do something wrong?

Re: Prints don't start after Tinkergnome Firmware Update

Posted: March 29th, 2018, 6:50 am
by reibuehl
With the stock firmware that ships with Cura 15.04, the printer prints fine. Strange...