Marlin 1.1.9 Setup Problems

Software and Firmware Discussion - related to source code, firmware updates, etc.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Marlin 1.1.9 Setup Problems

Post by Roberts_Clif »

Mr SNG wrote: October 21st, 2019, 4:44 pm So how do you tweak Z when the machine is printing?
Not sure I understand.

you can adjust Z Axis when printing using baby stepping
#define BABYSTEPPING

Though I believe your referring to Tweak at Z, you can Change printing parameters at a given height.
Tweak at Z.jpg
Tweak at Z.jpg (24.8 KiB) Viewed 6406 times
Mr SNG
Reactions:
Posts: 74
Joined: January 1st, 2018, 11:02 am
3D Printer(s): hictop auto leveling desktop 3d printer prusa i3

Re: Marlin 1.1.9 Setup Problems

Post by Mr SNG »

Just googled 'Marlin Baby Setting' now fully understand about this cool feature.

Thanks again for another useful heads up. 8-)
Post Reply

Return to “Software and Firmware Discussion”