Hi,
OK, have a Tronxy X5s-400 and considering upgrading the control board so I can incorporate some new features in Marlin 2.x and have a better control board.
I have a general idea of how to go about it, but want a base set of parameters to incorporate. Sometime in the past, I remember there was a G or M code that I could put in a terminal line that would spit out all the variables. Unfortunately, I either didn't save the info or have lost it somehow and now can't remember how to retrieve it.
Can somebody please tell me the G/M code to use so I can figure out the basic info such as steps/mm, type of thermistor etc.???
Thanks in advance.
Need help determining existing parameters Please
- Country_Bubba
- Reactions:
- Posts: 53
- Joined: June 8th, 2019, 10:12 am
- 3D Printer(s): Tronxy X5S-400, Ender5
- Contact:
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Need help determining existing parameters Please
M503: Report Settings - Marlin Firmware
Last edited by Roberts_Clif on December 31st, 2019, 10:49 am, edited 1 time in total.
- Country_Bubba
- Reactions:
- Posts: 53
- Joined: June 8th, 2019, 10:12 am
- 3D Printer(s): Tronxy X5S-400, Ender5
- Contact:
Re: Need help determining existing parameters Please
Thanks, that is what I was looking for!