Okay, so I got a 3D Printer from my brother recently that he originally bought from someone. he's had it for a year or 2 now, so I wanted to start from square one with updating firmware/configuration, so on.. the problem I'm running into is we don't know much about it other than it says it's a Prusa i3, and has a Tronxy Melzi 2.0 v5 board. I can't figure out which direction to go as far as firmware, configuration.h, etc. I'll leave pics of the printer and board down below in hopes to maybe identify the hardware I have and/or software I need. I have arduino installed on my pc and tried using Marlin but get nothing but errors when trying to compile a sketch based on a few videos I've watched. it seems like I'm getting nowhere with it so any help would be GREATLY appreciated! Thanks in advanced for any help
Prusa i3
Melzi2.0 V5 Tronxy
Newbie help, Prusa i3?
-
- Reactions:
- Posts: 1
- Joined: October 4th, 2020, 5:38 pm
- 3D Printer(s): Prusa 13
- Roberts_Clif
- Reactions:
- Posts: 1387
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Newbie help, Prusa i3?
Located a couple web sites that could be of help
https://forum.repetier.com/discussion/7 ... elzi-2-0v5
https://www.thingiverse.com/groups/tron ... opic:16233
This is the firmware for marlin for the tronxy P802E https://github.com/erikkallen/Marlin_tronxy
https://forum.repetier.com/discussion/7 ... elzi-2-0v5
https://www.thingiverse.com/groups/tron ... opic:16233
This is the firmware for marlin for the tronxy P802E https://github.com/erikkallen/Marlin_tronxy
Re: Newbie help, Prusa i3?
Thanks for the help links https aka ms remoteconnect Roberts. Ben looking for these from early morning.Roberts_Clif wrote: ↑October 5th, 2020, 7:16 am Located a couple web sites that could be of help
https://forum.repetier.com/discussion/7 ... elzi-2-0v5
https://www.thingiverse.com/groups/tron ... opic:16233
This is the firmware for marlin for the tronxy P802E https://github.com/erikkallen/Marlin_tronxy
Thanks again!