Have a print that has problems? Need some feedback? Post it here.
4 posts • Page 1 of 1
I'm trying to print some vessels, basically a cup to make a silicone mold for concrete reproductions. First layer is being wonky at one side. I tried several variations of the stl and they all did the same thing.
- Posts: 3951
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
That's very interestng that one side is flattening out. Check the belts? Something is up in the motion system